soundsation BEAM-ARC5-10W, Руководство пользователя

Страница: 6 / 10

Safety Instruction

Please conserve this manual as operation guidance. If you sell this product to other user, please
make sure that they also receive this user manual.

Always make sure that you are connecting to the proper voltage and that the line voltage you are
connecting to is not higher than that stated on the decal or rear panel of the fixture.

The fixture is intended to indoor use only. To prevent risk of fire or shock, do not expose fixture to
rain or moisture. Make sure there are no flammable, explosive or corrosive materials surrounded
in 0.5 meter while operating.

The unit must be installed in a location with adequate ventilation, at least 50CM away from
adjacent surfaces. Be sure that no ventilation slots are blocked.

Do not operate at ambient temperatures higher than 104
℉
(40
℃
).

Safe wire should be used to install machine. Bearing of safe wire should be 3 times of the
machine weight. Complimentary signal cable transmits signals to 20 unit fixtures at most. Signal
amplifier is a must to connect more fixtures. Sectional area of complimentary power cable is 1.5
㎡
.

Always disconnect from the power source before servicing or replacing fuse/lamp and be sure to
replace with same fuse/lamp size and type. Cut off power before moving, repairing and cleaning
the machine.

Secure fixture using a safety chain and carrying handles. Never carry the fixture by its cord.

In case of failure or misfunction occurred, stop using the unit immediately.

Repairs carried out by unskilled people can lead to damage or malfunction. Buy the same spare
parts/components from manufacturer directly.

To avoid electric shock, all fixtures must be connected to circuits with a suitable ground. Make
sure the power cord is never crimped or damaged. Do not power on and power off the fixture in a
short time. For your safety, do not touch fixture when running.

When use DMX controller, please make sure that there is no interference sources(e.g. intercom,
high frequency radio waves and radiation source)
Caution! There are no user serviceable parts inside the unit. Do not open the housing or attempt
any repairs yourself. In the unlikely event your unit may require service, please contact your local
distribution or after-sale service center.
CH10
Stand alone
speed
0-255 from slow to fast
CH11 Y run speed 0-255 from fast to slow
CH12 LED1
RGBW brightness adjust,2-31RED,32-61 GREEN,
62-91BLUE,92-121WHITE,122-151
RED+GREEN,152-181
RED+BLUE,182-2BLUE,212-G
REEN+BLUE,242-255 RED+GREEN+BLUE+WHITE
CH13 LED2
CH14 LED3
CH15 LED4
CH16 LED5
CH17 reset 0-254 not applicable
，
255 reset
6. Master-Slave control model
：
Set up one fixture as Master fixture(triggering), other fixtures as slave
fixtures(receiving trigger signals).Set up all fixtures
same address value or
following DMX controller performance(Attention: all fixtures use the same DMX
channel-12 or 17CH)
Specification:
Voltage
：
AC110V~240V
Frequency
：
50/60Hz
Rated Power: 120W
LED: 10WX5 RGBW 4IN1
Control
：
DMX512
Channel: 17/12 CH (switchable)
Control Mode
：
DMX/sound active/auto/ master-slave/manual
Level of Protection: IP20
Stock: Clean and Dry place
Running Temp.: 0°C~40°C
Weight: 6.5KG
Package Dimension: 58*8*20cm
For your safety
，
please read this user manual carefully before
operation. The machine should be operated by qualified engineer
！