Mounting the speaker
1. Measure a width of
15.7
inches on the wall.
2.
Mark the position of the mounting screws on the
wall using a pencil.
3.
Drill the supplied screws directly into the marks that
you have made on the wall and leave approximately
0.3
inch length to hook the Wireless Sound Bar.
4.
Put the Wireless Sound Bar onto the mounting
screws. Make sure they are firm and stable.
-
tscrew
Pairing the speaker with a Bluetooth
enabled device
1. Connect the AC power cord into a wall socket.
2.
Turn the speaker on by pressing the
[POWER]
button
on the speaker or remote control.
3. Press the
[MODE]
Button on the speaker or remote
control to enter Bluetooth Mode. A tone is heard and
the Bluetooth LED indicator light will flash quickly.
4. Keep the speaker and your Bluetooth enabled device
within three feet of each other during the pairing
process.
�- Set your mobile phone or other Bluetooth enabled
device to search for compatible Bluetooth devices.
() If there are no paired devices in range when
the speaker is turned on, it will go into
pairing mode automatically. If a paired
device is in range, the speaker will connect
to
it automatically.
On an iPhone
•Go to SETTINGS> BLUETOOTH (Make sure Bluetooth
is turned ON)
©
On a Blackberry
Bluetooth
Bluetooth
Devices
soundpal
Paired
Now discoverable
•Go to SETTINGS/OPTIONS> BLUETOOTH
• Enable BLUETOOTH (Make sure Bluetooth is turned
ON)
/
k
jtft#Mftl:
IM
=
Bluetooth:
�
Discoverable:
�
Paired Devices
[
Add New Device
J
CJOODD
0000000
0000000
0000000
DJ:::::::::::::JD
On an Android Phone
•Go to SETTINGS> BLUETOOTH >MENU> Search for
devices (Make sure Bluetooth is turned ON)
On other Cell Phones/Devices
• Review the instruction manual that came with your
phone/device.
Paired Devices:
(j)
Searching for devices
6.
7.
When your Bluetooth enabled device finds the
speaker, select "
soundpal
" from the list of
found devices.
If required, enter the password
0000
(four zeros).
Select OK or YES to pair the two units.
8.
A tone will sound indicating a successful pairing.
The Bluetooth LED indicator light will remain
solid, indicating that you are now connected.
NOTE:
If you would like to connect the speaker to
another device, you must disconnect the speaker
from the currently paired device first. On your
device's Bluetooth settings, select "
soundpal
'; then
select "disconnect" or"unpair''. When the speaker has
been unpaired, repeat the pairing process.
()
The screenshots above are typical of many Bluetooth
enabled devices in the market today, and are used
to
assist in the explanation of the pairing process.
Your Bluetooth enabled device's interface and
interaction with the speaker may differ slightly
from the illustrations shown.
Using the speaker
Powering ON/OFF
Turn the speaker ON and OFF by pressing the
[POWER]
button on the unit
or
the [<!)]key on the remote.
Adjusting the volume
• Quick press the
[VOL+�]
button on the speaker or
the [ +] key on the remote control to increase the
volume.
• Quick press the
[VOL
-
1'4'4]
button on the speaker or
the [ -] key on the remote control to decrease the
volume.
• Press the [l:©:] button on the remote control to mute
the sound. Press again to turn the sound back on.
Switching modes
Press the
[MODE]
button on the speaker or the remote
control repeatedly to switch between Bluetooth and
LINE IN modes.
