SoundPals DMIC-24, Руководство пользователя

Страница: 16 / 20

DMIC-24 User Guide
Page 10
•
Switch 5 defines the Copy Mode.
Function SW5
Inhibited 0
Permitted 1
•
Switch 6 and 7 defines the Category Code.
Function SW6 SW7
General 0 0
Digital Converter 1 0
Laser, CD 0 1
Magnetic Tape 1 1
•
Switch 8 determines the Generation Table .
Function SW8
1
st
Generation or Higher 0
Original 1
DMIC-24 Troubleshooting
The table below lists DMIC-24 problems and solutions.
Problem Procedure
No signal at either
AES output.
•
Is power applied? Check power LED and power supply.
No audio on AES
output. •
Is microphone connected correctly? Check
+
to pin 2, or ground to pin 3.
•
Does microphone require phantom power? Set Phantom Power Switch to UP
(
On ) position.
Front panel meters
not registering.
•
Is microphone sensitivity within SoundPals operating range?
•
Adjust sensitivity.
Ext Ref indicator not
lit on front panel.
•
Is AES reference connected? Check that an AES signal is applied to the
reference input if you want synchronized sampling.
•
Is the reference input a valid AES signal?
•
Is the reference input sampling frequency between 30 kHz and 50 kHz?
NOTE Please contact the GPS factory if the problem still exists after completing the
above procedures.