SoundPals ADLY-4A, Руководство пользователя

Страница: 7 / 16

ADLY-4/A User Guide
Page 4
3) X1 Frame Delay Switch — the 10-position rotary X1 Frame Delay Switch allows you to
select frame delay in multiples of 1 frame per step. (Note: frame rate is only accurate at
48kHz sample rate.)
4)
X.1 Frame Delay Switch
—
the 10-position rotary X.1 Frame Delay Switch allows you
to select frame delay in multiples of 0.1 (10
th
of a frame) frames per step. (Note: frame
rate is only accurate at 48kHz sample rate.)
5) Reference LED — when lit this green led indicates a valid AES reference either using
the external reference BNC’s or AES input channel 1 depending on the selection of the
Reference Switch on the rear of the unit.
6) Valid AES Input led’s — these four green led’s indicate you have a valid AES input for
each of the led’s that is illuminated.
7) PWR — the green Power LED lights when power is applied.
The figure below illustrates the ADLY-4/A’s rear panel:
PWR
G +
REF.
In
1
2
3 4
Out
1
2
3
5
4
1) Power Connector — accepts the power jack from the 6 VDC supply. Refer to “External
Power” for more information on external power.
2) AES Balanced Inputs — provides 4 AES balanced channel inputs via a 3 pin Phoenix
connector for each AES input channel.
3) External Reference AES3id Loop Thru BNC’s — provides a BNC external input
AES3id reference signal input, which can be looped thru, when the Reference Selection
Switch
is in the down position. Note that when not using these BNC’s as a loop-thru, the
open BNC should be terminated with 75 Ohms.*
4) Reference Selection Switch — in the down position selects the AES reference from the
External AES3id Reference BNC’s. In the up position selects AES input channel 1 as the
reference.*
5) AES Balanced Outputs — provides 4 AES balanced channel outputs via a 3 pin
Phoenix connector, one for each AES output channel.
* The AES reference signal, either external or AES channel 1, must have a sampling
frequency between 30kHz and 50kHz.