Please see reverse for Technical Specifications
INSTALLATION:
1) Detemine a clean, flat location
(typically the roof) on the vehicle to
mount the PINNACLE Mini Lightbar.
The PINNACLE Mini Lightbar comes
equipped with four magnetic feet. It
is the responsibility of the installer
and end user to determine whether
it is safe to use magnetic mounting
hardware for your application.
A Permanent Mount version
(EPL7PD(x)C) is available.
Note: The magnetic character of roof
steel varies from vehicle to vehicle.
Be sure that your vehicle is capable
of providing enough magnetic force
to safely secure the PINNACLE Mini
Lightbar to the roof.
2) A Protective Film has been provided
with the PINNACLE Mini Lightbar kit
that can be applied to the bottom of
each magnet. This film will protect
the paint of the vehicle. Apply one
donut shaped decal to the bottom of
each magnetic foot. Be sure to cover
the magnet entirely for maximum
protection to the paint finish.
Note: Protective film can reduce the
magnetic force by as much as 10%.
EPL7000 PINNACLE MINI
LIGHTBAR MAGNET MOUNT
(x)C
OPERATION:
Electrical Connections
& Flash Pattern Selection:
See diagram at left for Power ON ( ),
Power OFF ( ) and Pattern SELECT
( ) switch positions. Turn the light
on by pressing the Power ON button. To
change the flash pattern press and hold
the PATTERN SELECT button for one
to two (1-2) seconds. The PINNACLE
Mini Lightbar will advance one (1) flash
pattern and flash the new pattern each
time this is done. The PINNACLE Mini
Lightbar features non-volatile memory
and will recall last pattern used.
Selected pattern will remain the default
once turned off and can be changed
by changing the flash pattern before
powering off.
Power ON
Power OFF
Pattern SELECT
(x)A
•HIGH CURRENT interconnects must be properly terminated. Poor crimp quality can cause heat
build-up and fire. Follow crimp connector manufacturer instructions.
•DO NOT install this product or route any wires in the Air Bag Deployment Zone. Refer to vehicle
Owner’s Manual for deployment zones.
•Do NOT use system to disconnect headlights, brake lights or other safety equipment.
•Unit may become hot to touch during normal operation.
•Failure to properly install connectors, fuses or wiring may cause vehicle failure or fire.
•Installation must only be performed by trained technician. Installer must determine vehicle wiring
configuration and proper integration of system.
•Use proper wire gauge. All power wires connecting to positive (+) or negative (-) battery terminal
or local chassis ground (-) must be sized to supply at least 125% of max. current and properly fused at
power source.
•Install protective grommets when routing wire through firewall or metal.
WARNING
