ETSA100E.ETSA300MF 5/06
100/300 SERIES SIRENS
ETSA100E - ETSA300MF
Package Contents:
1ea.
Amplifier Box with Microphone
1ea.
Microphone Bracket w/ mounting hardware
2ea.
Amplifier Wire Harnesses with Connectors (1-12 Pin and 1-4 Pin)
1ea. Instruction
Manual.
1ea.
Operators warning card to remain in vehicle for operator review
1ea.
Sound Pressure warning label that is to be attached in vehicle and
in plain site of operator and occupants of the vehicle
Wire capacity requirements for siren amplifier
0-10 Feet:
14 AWG
10-20 Feet:
12 AWG
20-30 Feet:
10 AWG
30+ Feet:
Consult Factory to determine requirements
IMPORTANT NOTICE TO INSTALLER:
Make sure to read
and understand all instructions and warnings before proceeding with the
installation of this product. Ensure the manual and all warning cards are
delivered to the end user of this equipment.
Introduction
The ETSA100E and ETSA300MF Multi Function Siren Amplifier are
premium 200W units designed for single or dual 100W speaker use. The
sirens comes standard with a noise-cancelling microphone for PA use. The
amplifier box contains a single amplifier capable of supplying sound to
either 1 - 100 Watt or 2 - 100 Watt speakers. The ETSA300MF also
includes a 4 position slide switch and 4 independently controlled accessory
switches each capable of supplying 20 amps.
The primary operating modes are Piercer, Yelp, Wail, Hi-Lo, and Super
Hi-Lo, Manual, and Radio. A Noise Canceling PA Override, a push-button
Horn Override, and a push-button Manual Override are available in all
modes. All tones except wail and yelp for California Title 13 compliance
may be disabled by removing a jumper located on the PCB.
Sirens provide an essential function of an effective audio / visual warning
system. However, sirens are only short range secondary devices. The
use of a siren does not insure that all drivers can or will abide by or react to
an emergency warning signal, especially at high rates of speeds or long
distances. The operator of the vehicle must never take the right of way for
granted and it is the operator's responsibility to proceed safely.
The effectiveness of this siren system is highly dependant on the correct
mounting and wiring. The installer must read and follow the manufacturer's
installation instructions and warnings in the manual. The vehicle operator
should verify the siren system is securely fastened to the vehicle and
properly functioning.
Effective sirens generate loud sound pressure levels that can potentially
cause hearing damage. Installers and those around the vehicle need to be
aware of the dangers and wear hearing protection whenever the siren
system is operating. Vehicle operators and occupants should assess their
exposure to siren noise and determine what steps need to be taken to
prevent hearing damage.
The siren system is intended for use by authorized personnel only. It is the
user's responsibility to ensure they understand and operate the emergency
warning devices in compliance with all applicable city, state, and federal
laws and regulations.
SoundOff Signal assumes no liability for any loss resulting from the use of
this warning device.
WARNING
: Warning devices are strictly
regulated and governed by Federal, State
and Municipal ordinances. These devices
shall be used ONLY on approved vehicles.
It is the sole responsibility of the user of
these devices to ensure compliance.
WARNING
!
Sirens produce loud sounds that
may damage hearing
I
Roll up windows
I
Wear hearing protection
I
Use only for emergency response
I
Avoid exposure to siren sound
outside of vehicle
ETSA300MF SHOWN
