SoundMax SM-DVD5107, Инструкция по эксплуатации

Страница: 8 / 40

8
Battery installation
1. Remove the battery compartment cover on the back of the RC.
2. Insert the batteries into the battery compartment making sure that the correct
polarity is observed.
3. Install the cover back.
Use two AAA/1.5V batteries for the RC. The RC should be pointed at remote sensor
within 8 meters and within 30 degrees at the left or the right side.
Take the battery out of the RC if it is not used for a long time.
Do not mix new and used batteries or different types of batteries. Weak batteries
can leak and severely damage the RC
Connection
Note: Before you start connection of external devices, ensure that power of the unit is switched off.
Following outputs are available in this unit.
Composite video
Use the cable with yellow plug of an AV cable to connect the composite video output of this unit to the video input of a
TV/monitor.
SCART
Use a 21-pin SCART cable to connect the SCART output of this unit to the TV/monitor SCART input.
Stereo audio
Use a pair of AV cables (red for right/white for left) to connect the stereo audio outputs of this unit to the TV or a stereo
input of power amplifier.
Coaxial digital audio
Use a special coaxial cable to connect the coaxial output of this unit to the coaxial input of an external device (e.g. amplifier
with in-built DTS-decoder).
Notes:
The connection you should make depends on the TV/monitor input terminals. Don’t make all the connections at the
same time; otherwise the produced picture will be affected.
The physical connection should accord to the audio output setup of this unit.
The unit does not support DTS sound output. To obtain DTS format sound you need to connect the unit to an external
amplifier with the help of a coaxial cable (not included).