UR6700
/ English Instruction Manual
4
FM RDS DISPLAY INFORMATION
Press the “
MENU / INFO / BACK
” button repeatedly to cycle through the RDS (Radio Data
System) information (such as radio text, program type, time and date, if available).
FM MENU
1. In FM
mode, press and hold the “
MENU / INFO / BACK
” button to enter the FM menu.
2.
Select with “ ” or “ ” the below options and confirm with “
SELECT
”.
➢
Scan: To
define how the radio scans for the next available station. Select “DX” to search
for strong stations only, or “LOCAL” to search for all stations regardless of the signal
strength.
➢
System: see chapter “SYSTEM MENU”.
TOUCH CONTROL LED NIGHT LIGHT
Allows you to project the time on any wall around the room.
1. To activate the projection, press the "ON / OFF"
button.
2. With the rotating projection mechanism, you can adjust
the angle by 180 degrees.
3. If the projection on your desired wall or ceiling should
be upside down, press the "180 ° FLIP" button to
display the display correctly.
ALARM
SETTING ALARM
You can program 2 alarm settings.
1.
Press the
“
ALARM
” button to select between Alarm 1 and Alarm 2 and then press the
“
SELECT
” button to confirm the selection.
2.
Set with
“ ” or “ ” alarm “ON” and then press the “
SELECT
” button to confirm the
selection.
3.
With
“ ” or “ ” set the hour of the alarm and confirm with the “
SELECT
” button.
4.
Set with
“ ” or “ ”the minute of the alarm and press again the “
SELECT
” button.
5.
Choose with
“ ” or “ ” the alarm frequency options and confirm the selection with
“
SELECT
”. The alarm frequency defines how often the alarm is active.
Frequency options
: Daily, Once, Weekends and Weekdays. If “Once” is selected, you will
also be prompted to set a specific date.
6.
Press the
“ ” or “ ” button to cycle through the source options and then press the
“
SELECT
” button to confirm the selection. The source defines the sound source of the
alarm.
Source options:
DAB, FM and Buzzer. If DAB or FM is selected, the last played station
will be used as the alarm.
7.
Adjust with the
“ ” or “ ” button the volume level and press the “
SELECT
” button. This
setting defines the volume of the alarm. The alarm setting is now saved.
When the alarm setting is active (ON), the corresponding alarm icon (1 or 2) is visible on the
display. At the set time, the alarm will sound. The volume will increase gradually until it reaches
