Operating Instructions
Make sure the AC power cords from system are properly connected to AC 220-240V~50Hz
house
1) Power on the unit by turning the Mode Switch.
2) Power On Indicator will glow at the same time.
3) Select FM or AM band.
4) Adjust the desired station as follows:
Turn the frequency tuning knob in clockwise to select the best reception and stop on the station.
At this moment, the tuning indicator will glow brightest. Repeat this procedure until reaching on
your desired station.
5)
If you achieve the station, the tuning indicator will glow on the main unit.
6)
Adjust the volume control as desired by volume knob.
7)
Turn the Mode Switch to OFF when finish listening.
ANTENNA INFORMATION
FM
Make sure the FM lead wire antenna is unwound and extended to its full length. It may be
necessary to vary the direction of this wire antenna until you find the position that provides the best
reception for your favorite FM station.
AM
The AM ferrite bar antenna is inside the main unit. If AM reception is unsatisfactory, you may have
to turn the main unit slightly unit you find the position that provides the best reception.
ROBBER FEET INSTALLATION
Before installation, use a polishing cloth or dry cloth to wipe off dust and dirt on the bottom of the
units. The rubber feet come with self-adhesive tape. Put the rubber feet on the four corners of the
bottom of the unit.
Care and Maintenance
Care of the Radio Set
If the radio set becomes dusty wipe it with a soft dust cloth. Do no use any wax, polish sprays, or
abrasive cleaners on the set.
Caution
Never allow any water or other liquid to get inside the unit while cleaning.
The radio shall not be exposed to dripping or splashing and that no objects filled with liquids, such
as vases, shall be placed on the radio.
Specifications
FM Frequency
87.5 – 108MHz
AM Frequency
540 – 1600 KHz
Speaker Output Power
6W RMS / 50W P.M.P.O
Power Supply
230V~50Hz
Specification and the design are subject to possible modifications without notice due to improvement.
Gb 2
