11
GAIN SETING
Ø
Media with sine wave test tone 60Hz
recorded at 0db;
This procedure is the same for both
Ø
gain controls;
Necessary equipament:
GAIN SETING
Ø
Disconnect the output cables from the
amplifier outputs;
Set up procedure
Ø
Turn off all processing (bass, treble,
loudness, EQ, etc.);
Ø
Set the source unit's fader control to
center position;
Ø
Increase the gain control until the target
voltage is observed with the voltmeter
(see the chart below);
Ø
Connect the AC voltmeter to the
speaker output connectors of the
amplifier. Make sure you test the
voltage at the correct connectors (+
and –);
Ø
Digital AC voltmeter;
Ø
Screwdriver 1/8" ( for gain set)
Ø
Turn the gain control all the way down.
Ø
Set the source unit volume to 3/4 of full
volume.
Ø
Use a 60 Hz sine wave
Ø
Once you have adjusted the amplifier
to its correct voltage output, turn off the
s o u r c e u n i t a n d r e c o n n e c t t h e
speaker(s)
D o w n l o a d t h e t r a c k s f o r s e t u p i n
https://soundigital.com/en/downloads/
Ø
Set the crossover selector switch in "F»
MODEL
BRIDGE / POWER
STEREO / POWER
STEREO OUTPUT VOLTAGE
BRIDGE OUTPUT VOLTAGE
4 /400W
2 / 200W
20 V
40 V
Ω
Ω
400.2
