On the front panel you will see the following dials:
A
Use this dial to select action time i.e. how long does the
SoundEar’s noise limit have to be exceeded (red ear) before
the SoundBuster reacts.
B
Use this dial to select reset time, i.e. how long before
SoundBuster automatically resets and restarts. For manual
reset, choose: ∞
Beskrivelse af LED
1. The Green LED lights up
when the
SoundBuster is switched on and the
alarm cable is connected to a Sound-
Ear that is also switched on, and the
noise level is not exceeded.
2. . The green LED starts to flash
when
SoundEar’s signal level is exceeded
but not the preset time limit on dial
A.
3. The Red LED lights up
once the
noise limit has been exceeded for lon-
ger than the preset time limit on dial
A. SoundBuster will then reset and
restart as long as the noise limit is not
exceeded again within the preset time
limit on dial B.
4. The Red LED will flash
if an alarm
occurs after SoundBuster has cut off
the power output. (Make sure the
alarm cable is connected properly and
that the SoundEar is working.)
Settings dials and LED
Socket for
AC adapter
Jack plug
3,5 mm
mono
Mains output
IEC device socket
Max. 8A
Mains input
IEC power cable
Instructions Leaflet for SoundBuster page 2
For professionals / Electrical diagram
NC
NO
1
2
3
JC
1
2
3
31
IEC-C13
1
2
3
32
IEC-C14
The power consumption must
not exceed the approved current
for the plug and cable (usually
8-10A)
Plug
Input
Socket
Output
Phase (Load/Live)
Earth (PE)
PCB
Mounting box
Neutral (N)
Relay
