Spirit Digital 328 v2
6
AES/EBU Input:
Press
<MENU>
, and use the PARAM encoder to scroll down until ‘AES/EBU I/P Set.’ is the
highlighted menu. Press
<ENTER>
and route the AES/EBU input as required, from a choice of
stereo inputs 1 and 2, FX returns 1 and 2 or as a dedicated 2 Track input. The AES/EBU input
can also be routed to ‘NOWHERE’, which is the default setting, in which case the signal is muted.
AES/EBU Output:
Press
<MENU>
, and use the PARAM encoder to scroll down until ‘AES/EBU O/P Set.’ is the
highlighted menu. Press
<ENTER>
and route the AES/EBU output as required, from a choice of
the mix bus, aux outputs 1/2 or 3/4, or FX sends 1/2.
To set the wordlength of the AES/EBU output, press the down cursor from the above menu page.
The wordlength options are 16, 20 or 24 bit. Note that 16 and 20 bit settings are dithered and
24 bit is undithered.
To set the status bits within the AES/EBU output stream * , press the down cursor. By default
the AES/EBU output status bits setting of ‘AUTO’ sets the sample rate flag to 48kHz and the pro
flag to on. To set these manually, you should use the PARAM encoder to set the status bits to
MAN. Press the down cursor again to set the sample rate flag and again to set the pro flag on or
off.
AES/EBU Input And Output Configuration
AES/EBU Input And Output Configuration
AES/EBU Input And Output Configuration
AES/EBU Input And Output Configuration
< AES/EBU Input >
Route To: 2TRK
<AES/EBU Output>
Src From: MIX
<AES/EBU Output>
Wordlength: 16
<AES/EBU Output>
S/Rate Flag:44k1
<AES/EBU Output>
Pro Flag: OFF
Assigning the S/PDIF input will override any analogue signal present at
the selected input. The S/PDIF and AES/EBU inputs cannot be routed
NOTE
* Individual DAT recorder models may require different settings.
Consult the DAT Recorder Setup section of this setup guide and
documentation specific to the DAT recorder model.
NOTE
