If you need to replace the power fuse, replace it only with a fuse identical
to that supplied with the system. Using a fuse of different type or rating may
result in damage to your system which isn't covered by the manufacturer's
warranty.
- 9 -
- 10 -
Electrical Wiring
Measure the hole centers and mark with a felt tip pen.
Mounting the Amplifier
Mark the location for the mounting screw holes by positioning the amplifier where
you wish to install it and use a scribe (or one of the mounting screws) inserted in each
mounting hole to mark the mounting surface. If the mounting surface is carpeted,
Fuses
Fuses protect both the amplifier and the electrical system of your vehicle from faulty
conditions. If you must replace the fuse in your SLADE D3000SL amplifier, use a fuse
of exactly the same type and rating. A different type or rating may result in damage or
cause a fire.
Remote Subwoofer Level Control
Your SLADE D3000SL is equipped with a dashboard mount remote subwoofer level
control. Run the supplied dashboard remote control from the front panel of your amplifier.
By turning the level knob clockwise, you will increase the output of low frequencies.
Wire the amplifier directly to the car battery. Make sure there is circuit protection
(such as a fuse) on the positive power lead, within 18 inches of the battery.
All SOUND STORM SLADE series power amplifiers are equipped with easy
top access screw terminals. These terminals are n
in order to ensure
excellent electrical contact and to resist corrosion.
ickel-plated
When making electrical connections to the amplifier, please observe the following:
Use at least 8 gauge or heavier wire for power and ground connections.
For the ground connection, use the shortest possible wire to a good chassis
ground point.
Wire the Remote connection to the remote turn-on lead of your equalizer or head
unit. In some cases this may be the power antenna lead of the head unit.
Drill pilot holes in the mounting surface for the mounting screws and insert the mounting
screws into these holes. Tighten them securely.
Note: Before beginning your installation, be sure to take note of any wires, lines or
other devices in your vehicle which may be located behind any mounting surface
.