6
The following graph shows the correct wiring for connecting un-
balanced signals to the balanced XLR connectors.
VERY IMPORTANT
Phantom power must be switched off before unbalanced signals
are connected! Otherwise short circuits cause damages!
Built around a torroidal transformer, the power supply allows for a
minimal electromagnetic field with no hum or mechanical noise.
The supply voltage can be set to 230 V/50 Hz or 115 V/60 Hz.
Check your country's power requirements for the appropriate
setting. An AC power cord is included to feed the IEC-spec, 3-
prong connector. Transformer, AC cord and IEC-receptacle are
VDE, UL and CSA approved. The main fuses are rated at 315mA
(230 V) and 500 mA (115 V).
Chassis ground and AC ground can be physically disconnected
by the “Ground Lift” switch (GND LIFT). This helps to eliminate
hums.The power supply's output side is filtered by an RC circuit to
extract noise and hums caused by your power service. 6000µf
capacitors smooth out the positive and negative half waves.
The phantom power is derived from a separate winding in the
transformer. Filtered and rectified by a series of zener diodes and
transistors, a clean 48 volts leaves the circuitry.This supply voltage
reaches the phantom power switch through the PCB where
another RC circuit stabilises the supply again. Our high quality
0.1% / 6,81 kOhm resistors ensure the pristine quality of the
phantom power supply.
A stable, low ripple torroidal power
supply is the foundation for any
high-fidelity sound shaping.
The GND-LIFT switch helps
eliminate hums caused by
ground loops.
Phantom Power with a complex
filtering scheme and highly
selected components.
Power Supply
