6
PREINSTALLATION
Please prepare sufficiently to layout your car space before installation. We
recommend to have the installation done by an Autho rized SOUNDMAGUS
Dealer.
Please use good insulated power cable to endure longterm above 40A
electronical current. The +12 Volt power cable must be connected with a
fuse in line near 20cm of terminal. Required current, power
cable and proper external fuse listed as following:
MODEL
CABLE
FUSE
SE800
.
1
4
#
80
A
SE1500
.
1
2
-
4
#
120
A
SE2000
.
1
0
-
4
#
200
A
SE3500
.
1
0
-
2
#
300
A
SE90
.
2
8
#
30
A
SE150
.
2
4
-
8
#
40
A
SE90
.
4
40
A
SE150
.
4
4
-
6
#
60
A
4
-
8
#
Please use car audio RCA cables, otherwise it may be disturbed. Keep
these cables as short as possible. To avoid disturbances from your car
electronics, please don`t close the existing car cables when you install
the RCA cables.
Don't expose any cables out of car. Please take care insulated cables to
avoid damaging when cables pass through metal, rubber and plastic
etc. Don't install all cables too tight.
The ground wire should be connected directly with the chassis of your
vehicle which should be metal to metal ground point connection.
The amplifier must be mounted securely at a solid, dry and low vibration
surface in the trunk or passenger area. Fix the amplifier in an open air
area to insure proper heat dissipation.
5
CONTROLS & FUNCTIONS
SE800
.
1
/
SE1500
.
1
SE2000
.
1
/
SE3500
.
1
SE90.2/SE150.2
SE90.4/SE150.4
with a minimum level of 200mV is required for proper operation. The use of high quality twisted
pair cables is recommended to decrease the possibility of radiated noise entering the system.
These RCA input jacks are for use with source units that have RCA outputs. A source unit
5. RCA Input Jacks
The red LED will light up and will be flashing if there is a fault presented to the amplifier.
Please disconnect the amplifier and resolve the fault before reconnecting the amplifier.
7. Alarm Indicator
This LED will light up when amplifier works properly.
8. RUN
WI - FI adapter. Connection amplifier and adapter wap - set crossover and function. Once set
up completed, WI - FI adapter can be pulled out, latest settings will be saved in the amplifier.
6. I/O PORT
