polarity.
Step3: Screw the cover back to the microphone compartment tube.
Operating
1.
Turn on the main unit of the infrared teaching amplifier system and the other equipment.
*The system will not receive any signal for approximately 5 seconds after the power is
turned on.
2.
Remove the battery compartment tube cover and set the channel to the desire one.
3.
Turn on the microphones.
When the microphone is turn on, the green power indicator light should be illuminated.
If the battery is low, this indicator light will turn to red.
*Do not block emitter diodes with hand.
*Bring the microphone close to one of the infrared sensors and make sure the infrared
sensor picks up the microphone signal. (Do this while making sure that the other
infrared sensor cannot receive the signals.)
If the sensor does not receive the microphone's signal, or if the sensitivity is poor, check
the cable connection.
Bodypack IRT-1 Diagram and Instruction
Rechargeable battery Ni-MH type 1.2V / 2650mAH x2
1.
On / Off Switch
16
Содержание IR-89
Страница 26: ...26 ...