XL-SATA User Guide and Installation Instructions
3
5. Swing the small green circuit board over while pressing down on the ribbon cable to avoid snagging.
6. Carefully disconnect the ribbon head mating connector from the circuit board.
7. Remove the old hard drive and attached ribbon cable from the recorder.
8. Place the old hard drive assembly, and the fi ve 4-40 x 1.75” Black Oxide Phillips head screws off to the side as these are no
longer needed. DO NOT DISCARD THE TWO SMALL BLACK OXIDE PHILLIPS HEAD SCREWS.
9. Remove the XL-SATA Drive Interface from its packaging.
