6
/
7
www.
scpaudio.com
SPECIFICATION
Model
A
4100
A
4200
A
4300
A
4400
Description
Four Channel Power Amplifier
Rated Output 4Ω
4×170W
4×350W
4×500W
4×600W
Rated Output 8Ω
4×100W
4×200W
4×300W
4×400W
Bridge Out 4Ω
2×330W
2×600W
2×900W
2×1000W
Bridge Out 8Ω
2×160W
2×330W
2×500W
2×630W
Frequency Response
20Hz~20KHz
THD
<0.3%
S/N Ratio
>105dB
Input Impedance
20KΩ (bal.), 10KΩ (unbal.)
Crosstalk
>75dB
Connector
Input by XLR, 1V, 20KΩ (bal.), 10KΩ (unbal.)
Power Supply
AC 100~240V, 50/60Hz
Dimension
484×375×44mm
Net Weight
4.5kg
5.0kg
5.5kg
5.7kg
TROUBLESHOOTING
No power light on front
panel switch
Ensure IEC inlet is connected to mains and lead is in good condition
Ensure mains outlet is switched on
Power light is on but no
other LEDs and no output
Check input signal and connection leads
Ensure channel gain controls are not turned fully down
Power light and Signal
LEDs are lit but no output
Check speaker leads are in good condition and connected properly
If speakers/leads OK, switch off again and refer to qualified service personnel
Check speakers are in good working order and not shorted (use a multi-tester)
Case getting hot
Ensure cooling vents are clear and fan is working (refer to technician if not)
Output is very distorted
and CLIP LEDs are
lighting
Check the speaker impedance is not below the rated Ohms
Turn down the input level from audio source
Turn down channel gain controls
Output is working but at
very low level
Ensure input source is at line level
Increase input level from audio source
Turn up channel gain controls
