Introduction
Congratulations and thank you for purchasing a Sound Acoustics product. The
PRO-RVC is a stand alone flush wall mounted microphone/line mixer that can
operate independently or with Sound Acoustics amplifiers. The PRO-RVC is
perfect for adding extra inputs to an audio systems with remote control of mix
balance and master volume control. Please read this entire manual to get the
most from your Sound Acoustics PRO-RVC.
Includes:
1 x PRO-RVC mic/line mixer
2 x Mounting Screws
1 x Installation manual
3 x Knob security covers
Connecting to Sound Acoustics Amplifiers:
Ensure the amplifier is powered off and unplugged from the wall ac outlet
before making connections.
Carefully unpack the PRO-RVC.
Run a Cat5, Cat5e or Cat6 cable from the amplifier to the PRO-RVC location.
Terminate the wire in a single gang electrical box or use a drywall mud ring at
the PRO-RVC location.
Caution:
Ensure the connections (pinnings) are exactly the same at both ends
of the cable. See diagram below.
The back panel of the PRO-RVC provides two RJ45 female jacks. OUT1 (to
amplifier) and IN1 (from additional PRO-RVC's) Push the connector/cable into
the jack until the jack clicks and is seated firmly. All Sound Acoustics amplifiers
provide a back panel RJ45 female jack for connecting the PRO-RVC. When using
multiple PRO-RVC's (max 3) connect the OUT1 from PRO-RVC # 2 to the IN1 of
the first PRO-RVC and repeat for PRO-RVC #3. See the following diagram.
