KITS05WMA 1/2” Air Operated Diaphragm Pump
Wall Mount Bracket Installation Instructions
WARNING!
Use
cau on
when
installing
the
bracket,
pump,
and
associated
parts.
Use
required
safety
equipment
(goggles,
gloves,
etc.).
Be
certain
the
bracket
and
pump
are
securely
installed
prior
to
opera on.
Required
tools:
3/8”
socket
or
nut
driver
7/16”
socket
or
nut
driver
Step 1:
Remove the 3/8” nuts on
the back of the pump body
one
at a time
(Figure 1). This is best
accomplished by loosening the
bolts on the
front one at a time
(Figure 2); once each bolt is
loose, press it back into the hole
to push the nut out of the pump
body. Repeat for each nut.
Figure 1
Figure 2
Step 2:
Press the coupler nuts
one at a time
into the pump
body and tighten the 3/8” bolts
to secure them into place
(Figure 3).
Torque them to 25
inch pounds.
NOTE!
Install exhaust
components (muffler, etc.)
PRIOR
to installing the bracket
on the pump.
Step 3:
Attach the bracket to
the to the back of the pump
(Figure 4) using the four 3/8”
bolts provided with the kit. The
bolts thread into the coupler
nuts; insert the 1/4” split
washers as indicated between
the bolt and the bracket.
Tighten the 3/8” bolts to 25 inch
lbs.
Figure 3
Figure 4
NOTE:
Bracket dimensional drawings on back.
