service record Airon
25 von 36
2021-06-10
3.8.1 Adjustable back upholstery
3.8
Back assembly
(1)
(A)
(3)
A
A
A
A
(2)
(B)
(A)
(C)
min. 8 cm
each side
min. 8 cm
each side
(4)
A
The adjustable back straps allow the back to be shaped individually. If, for example, the upper
straps on the back are loosely adjusted "to sag", the back is trough-shaped and thus more late-
ral torso stabilization for the wheelchair user.
(1)
Remove the back cushion
(A)
,
(2)
remove the back cover
(A)
of the Velcro
fasteners
(B)
,
(3)
Loosen the Velcro connection
(A)
of the
straps that are to be changed,
set a new length and close the Velcro connec-
tion again.
Put the back cover
(3A)
back over the Velcro
fasteners and close at the lower edge.
When using a stabilizing bar, the slack in the back covering must not be so great that the
back comes into contact with the stabilizer bar. Risk of pressure points!
(4)
The Velcro / fleece overlap must be
at least 8 cm per side.
Note that the adjustment of the back upholstery affects the center of gravity and the
tipping behavior of the wheelchair.
3.8.2 Stabilizer bar
If you would like to replace the back bar with a
stabilizer bar, please proceed as follows:
Loosen the screws (
5A
) and remove the back
bracket.
Now move the rod into the desired position
and fasten the screws (
6A
) on both sides.
When replacing the stabilizer bar with a new
stabilizer bar or exchanging the stabilizer bar
for a back bar, please proceed in the same
way.
(5)
(6)
(A)
(A)
