Sorel TDC 2, Инструкция по установке и эксплуатации

Страница: 14 / 36

14
Parametrisation
5 5
The first time the controller is turned
on and after the language and time
are set, a query appears as to
whether you want to parametrise the
controller using the commissioning
help or not. The commissioning help
can also be terminated or called up
again at any time in the special
functions menu. The commissioning
help guides you through the
5.1 Commissioning help
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.
5.2 Free commissioning
If you decide not to use the commissioning help, you should make the
necessary settings in the following sequence:
- Menu 10. Language (see 14.)
- Menu 7.2 Time and date (see 12.2)
- Menu 7.1 Program selection (see 12.1)
- Menu 5.
Settings, all values (see 10.)
- Menu 6. Protective functions if adaptations are necessary (see 11.)
- Menu 7. Special functions if additional changes are necessary (see 12.)
necessary basic settings in the correct order, and provides brief descriptions
of each parameter in the display.
Pressing the “esc
”
key takes you back to the previous value so you can
look at the selected setting again or adjust it if desired. Pressing the
“
esc“
more than once takes you back step by step to the selection mode, thus
cancelling the commissioning help. Finally, menu 4.2 under operating mode
“Manual
”
should be used to test the switch outputs with the consumers
connected, and to check the sensor values for plausibility. Then switch on
automatic mode.
Caution
Observe the explanations for the the individual parameters on the
following pages, and check whether further settings are necessary
for your application.
Finally, menu 4.2 under operating mode “Manual“ should be used to test the
switch outputs with the consumers connected, and to check the sensor values
for plausibility. Then switch on automatic mode.