Soozier A90-220V80, Инструкция по сборке

Страница: 9 / 12

How to know whether the machine needs lubrication:
Put your hand in the center of the back of the treadmill to check, if the
footboard is dry, it means that you must add lubricating silicone oil.
Steps for applying lubricating oil to the footboard:
A) Adjust the treadmill to the low speed operation of 1km / h.
b) Lift the treadmill on the back of the treadmill: put the oil container in the
middle of the treadmill, spray the silicone oil in the inner part of the running belt,
apply oil to both sides of the running belt and run the treadmill at a speed of
1km / h. The silicone oil will be fully absorbed by the treadmill in approximately
8-10 minutes.
NOTE
To extend the useful life of the machine, it’s recommended that you turn off the
power after using it 2 hours continuously and let the machine to have a rest for
10 minutes before using it again.
Adjustment of the running belt
If the belt is too loose, it will slip when you run on it. If it is too tight, it can
reduce engine performance and cause the abrasion on roller.
All treadmills have to be adjusted the running belt before leaving the factory
and after installation. However, it may still be loose after using it for a period.
When the treadmill is out of adjustment, a slip phenomenon
occurs while exercising. When this phenomenon occurs,
adjust the adjustment bolts of the running belt to left and
to right.
If you want to tighten the belt, go backwards and operate counterclockwise. If
the belt is too loose and you put your foot on it, the belt and roller will slip, this
will cause damage to the motor, running belt and roller.
Screws of
adjustment