1-6
YS-W270/W270P (E)
10
(GB)
75
Ω
Connections
Notes on Connections
• This unit will only operate when connected to a Sony
SSC-series camera or the SPT-M320/M320CE video
camera with multiplex transmission capability. When
making the connections, refer also to the operation
manual for the connected video camera module.
• Turn off the power to all the equipment while making
the system connections. If you connect a camera to
this unit after switching the power on, the camera will
not be supplied with power.
• The cables connecting this unit to the video cameras
carry the power supply and synchronization signal in
addition to the camera video output signal. It is
therefore not possible to add a booster or other device
between the unit and a camera.
• Always use a 75-ohm coaxial cable of the length
specified in the tables on page 8 (GB) when connecting
a video camera to this unit; use of an incorrect cable can
lead to camera malfunction. Also be sure to set the cable
compensation switch correctly.
Using One YS-W270/W270P
Using one YS-W270/W270P you can set up a system
of up to four cameras, with two monitors for each
camera.
Picture from camera 4
Picture from camera 3
Picture from camera 2
Picture from camera 1
Picture from camera 4
Picture from camera 3
Picture from camera 2
Picture from camera 1
Video monitor
to CAMERA
IN 1 to 4
to video input
connector
to video input
connector
to an AC outlet
Video monitor
to VIDEO
OUT A 1
to 4
to DC IN. VS IN/
VIDEO OUT
YS-W270/W270P
75
Ω
: ON
[SYNC MODE:
PRIMARY]
Make all the connections before setting the POWER
switch of this unit to ON.
Video signal flow
(Front)
4
3
2
1
Camera
to VIDEO
OUT B 1
to 4
11
(GB)
B
Connecting more than one camera adaptor
Using the synchronization signals from the YS-W270/
W270P or external unit allows you to synchronize the
cameras connected to second or more camera adaptors.
Connecting two camera adaptors 1:
Synchronizing the cameras by the synchronization signals from the YS-W270/
W270P
Note
If you use external synchronization signals (SYNC
MODE: SECONDARY), you need to set the SYNC
SYSTEM switch to VS or VD according to the signals
input to the SYNC IN connector, otherwise the
camera(s) will not be synchronized.
Picture from camera 3
Picture from camera 2
Picture from camera 1
Video monitor
Picture from camera 4
to CAMERA
IN 1 to 4
Video monitor
Picture from camera 6
Picture from camera 5
Picture from camera 7
Picture from camera 8
to SYNC IN
Video signal flow
1
2
3
4
5
6
7
8
to VIDEO OUT
1 to 4
75
Ω
: ON
YS-W270/W270P
YS-W270/W270P
75
Ω
: ON
to DC IN.VS IN/VIDEO OUT
to VIDEO
OUT 1 to 4
to an AC outlet
to an AC outlet
to DC IN. VS IN/VIDEO OUT
to video input connector
Camera
to CAMERA
IN 1 to 4
to video input connector
Camera
to SYNC
OUT
[SYNC MODE:
PRIMARY]
(Front)
[SYNC MODE:
SECONDARY]
(Front)