Sony XR-4800, Руководство по обслуживанию

Страница: 26 / 37

– 39 –
Pin No. Pin Name I/O Function
65 LCDCKO O Serial data transfer clock signal output to the liquid crystal display driver (IC901)
66 LCDSO O Serial data output to the liquid crystal display driver (IC901)
67 LCDINH O
Blank indicate control signal output to the liquid crystal display driver (IC901)
“L”: no display
68 UNICKI I Serial data reading clock signal input terminal for the unilink Not used (open)
69 UNISO O Serial data output terminal for the unilink Not used (open)
70 UNISI I Serial data input terminal for the unilink Not used (fixed at “L”)
71 UNICKO O Serial data transfer clock signal output terminal for the unilink Not used (open)
72 BUSON O Bus on/off control signal output terminal Not used (pull down)
73 SYSRST O Reset signal output terminal “L”: reset Not used (pull down)
74 VREG O CPU regulator output terminal Connected to capacitor
75 GND — Ground terminal
76 X OUT O Main system clock output terminal (4.5 MHz)
77 X IN I Main system clock input terminal (4.5 MHz)
78 CE I CPU chip enable signal input (fixed at “H”)
79 VDD1 — Power supply terminal (+5V)
80 RESET I
System reset signal input from the reset signal generator (IC502) and reset switch (S503)
“L” is input for several 100 msec after power on, then it changes to “H”
*1 loading/tape operation motor control
MODE
TERMINAL
LM LOD (pin
8
) “L” “H” “L” “H”
LM EJ (pin
9
) “L” “L” “H” “H”
STOP
LOADING/
FORWARD
EJECT/
REVERSE
BRAKE