Sony Electronics Inc. • 16530 Via Esprillo • San Diego, CA 92127 • 1.800.222.7669 • www.sony.com
Last Updated: 04/13/2011
XM-GTX1302
2/1 channel GTX amp
Please visit the Dealer Source for current information at
www.sony.com/dealersource
Features
130 Watts x 2 RMS at 4 Ohms
1
280 Watts x 2 max power at 4 Ohms
170 Watts x 2 RMS at 2 Ohms
400 Watts x 2 max power at 2 Ohms
340 Watts x 1 RMS at 4 Ohms
800 Watts x 1 max power at 4 Ohms
This unit can be used as
a bridging amplifier with a maximum output of 800 Watts at 4
Ohms.
High Level input with Sensing Power On
Direct connection
(High Level Input) can be made with the speaker output of
your car audio unit if it is not equipped with RCA line output. Hi-
Level Sensing power On feature allows the unit to be activated
without need for remote connection.
80 Hz Low-pass filter, 18 dB/oct
Built in 80Hz 18 dB/Oct LPF
(Low Pass Filter) enables users to concentrate the power on
lower frequencies.
80 Hz High-pass filter, 12 dB/oct
Built in 80Hz 12 dB/Oct HPF
(Hi-Pass Filter) enables users to block low frequencies to
improve the audio systems efficiency.
0-10 dB Variable 40Hz Low boost
Variable 0-10 dB 40Hz bass
boost provides additional bass response at lower frequencies.
Specifications
Audio
Frequency Response:
5 - 50 kHz (+0/-3 dB)
Input Level:
0.3 - 6.0V (RCA input) or 1.2 - 12.0V (High Level Input)
Impedance:
2-8 Ohms Stereo or 4-8 Ohms Mono
Operation:
2/1 channel configuration
Tone Control(s):
Low Pass Filter: 80Hz, 18dB/Oct
High Pass Filter: 80Hz, 12dB/Oct
Harmonic Distortion:
0.05% (at 1kHz)
Low Boost:
0-10dB Variable (at 40Hz)
Signal-to-Noise Ratio (dB):
93 dBA
Power
Output Power:
Maximum Output: 280 Watts x2 or 800 Watts x1
(at 4 Ohms)
Current Drain:
At rated output: 30A (at 4 Ohms)
Remote Input: 1 mA
Rated Output:
(20Hz-20kHz, 1% THD+N, 14.4V) 130 Watts x 2
RMS (4 Ohms)
170 Watts x 2 RMS (2 Ohms)
340 Watts x 1 RMS Mono (4 Ohms)
Power Requirements:
12V DC Car Battery (Negative Ground)
Internal Power Supply:
OTL Output Transformerless Circuit
Pulse Power Supply
Input Voltage:
10.5-16V Power Supply Voltage
Inputs and Outputs
RCA Audio Input(s):
Pin Jacks: 0.3 - 6V
Audio In:
RCA Pin Jacks, High Level Input Connector
1
Audio Out:
Speaker terminals with screws
Dimensions
Weight:
6 lbs. 10 oz.
Measurements:
15 1/8" x 2 1/4" x 10" (384 x 55 x 252 mm)
Supplied Accessories
Mounting Screws (4)
High Level Input Cord (1)
Protection cap (1)
Color:
Gray and Silver
UPC Code:
027242773059
1. CEA-2006 Compliant — Standardized “Voluntary” Testing & Measurement Methods for Mobile Audio
Amplifiers. This standard advocates a uniform method for determining an amplifier’s RMS power and signal-
to-noise ratio. Using 14.4 volts, RMS watts are measured into a 4-ohm impedance load at 1 percent Total
Harmonic Distortion (THD) plus noise, at a frequency range (for general purpose amplifiers) of 20 Hz to
20,000 Hz.
© 2010 Sony Electronics Inc. All rights reserved. Reproduction in whole or in part without written permission is
prohibited. Sony, Quick-BrowZer, Walkman, Xpl
ō
d, ZAPPIN, and the Sony and Xpl
ō
d logos are trademarks of
Sony. iPod is a trademark of Apple Inc. All other trademarks are trademarks of their respective owners.
Features and specifications are subject to change without notice. Non-metric weights and measures are
approximate and may vary.
