SRS-NWGT10 4-124-112-
12
(1)
Installation
1
Set up the stand located on the rear side of the system
, connect the AC
power adaptor
, and put the plug of the AC power adaptor in the wall outlet
.
To the wall outlet
To DC IN 5.2V jack
2
Set the supplied attachment into the system until it clicks as shown in the
illustration.
Set the attachment for use with your “WALKMAN” model. Each attachment has the
identification mark (E) for the NWZ-E430F series and (S) for the NWZ-S730F/S630F series.
3
Install the “WALKMAN” in the system.
Make sure that the “WALKMAN” is placed properly in the WM-PORT of the system for
proper connection.
Listening to Music
1
Play back content on your “WALKMAN.”
2
Press the /– button on the system to adjust the volume.
/− button
Hints
You can perform playback on your “WALKMAN” installed in the system without
connecting the AC power adaptor.
For details on how to perform playback on your “WALKMAN,” refer to the “Operation
Guide” supplied with your “WALKMAN.”
Notes
When playing on your “WALKMAN” without the AC power adaptor connected, volume
output from the system is reduced. The battery of your “WALKMAN” is also consumed.
If you want to adjust the volume, do so while your “WALKMAN” is installed. If you
disconnect the AC power adaptor during playback and also detach your “WALKMAN,” the
volume is reset to the default setting.
If your “WALKMAN” model’s headphone jack is on the same side as the WM-PORT jack,
you cannot use the FM radio function while your “WALKMAN” is installed into the
system.
When operating your “WALKMAN” while it is installed into the system, brace it with your
other hand.
Available playback time with no AC power adaptor connected
NWZ-E430F series: 16 hours (approx.)
NWZ-S730F/S630F series: 17 hours (approx.)
* When playing at MP3, 128 kbps
To recharge the battery of your “WALKMAN”
If you put your “WALKMAN” in the system while the AC power adaptor is connected, battery
charging starts automatically. Charging progress is displayed on the “WALKMAN.” For details,
refer to the “Operation Guide” supplied with your “WALKMAN.”
Troubleshooting
Should you encounter a problem with the system, find your problem in the troubleshooting
checklist below and take the indicated corrective action. If the problem persists, contact your
Sony dealer.
Note that if service personnel change some parts during repair, these parts may be retained.
When bringing the system in for repairs, be sure to bring in the entire system.
This product is a system product, and the entire system is needed to determine the problem.
There is no sound.
Make sure the AC power adaptor and power cord are securely connected.
Press the button to turn up the volume.
Make sure your “WALKMAN” is securely connected.
Make sure your “WALKMAN” is playing music.
There is a severe hum or noise.
Move the system away from any possible sources of noise.
Connect the AC power adaptor to a different mains.
The sound is distorted.
Press the VOLUME – button to reduce the volume.
Set the sound mode of the “WALKMAN” to normal or flat sound quality.
The stand becomes detached.
Install the stand into the system by following the procedure below.
Fit the upper right hinge of the stand on the right side pin on the rear of the system.
Be sure to fit the hinge on the right side pin first.
Hinge
Attach to right side pin.
Fit the other hinge on the left pin, and then press down the stand until it clicks.
