Sony VPLGH10, Руководство по эксплуатации

Страница: 57 / 155

57
GB
Ot
h
e
rs
On-screen display
Remote control
Others
Symptom Cause and Remedy
On-screen display does not
appear. c Set “Status” in the Setup menu to “On.” ( 1 page 46)
c Check if the ON/STANDBY indicator should light in green.
The model name does not
disappear from the screen.
Or else, the demo mode is
displayed continuously. c The display mode of the projector may be set at the time of
purchase. Consult with your local dealer or qualified Sony
personnel.
Symptom Cause and Remedy
The remote control does
not work. c Batteries could be weak. Replace them with new batteries.
(
1 page 11)
c
Insert the batteries with the correct polarities. (
1
page 11)
c If there is a fluorescent lamp near the remote control detector, the
projector may work improperly or inadvertently.
c
Set “IR Receiver” to “Front & Rear” on the Installation menu.
(
1
page 49)
Symptom Cause and Remedy
The fan is noisy. c Check the setting of “Cooling Setting” in the Setup menu.
( 1 page 46)
c
Make sure that the room temperature is not too high.
c
Check the installation conditions. (
1
page 12)
The number of fan rotation increases to maintain the product
reliability of the projector’s components in a room, where the
temperature is higher than normal. The fan noise becomes
slightly louder. The approximate normal temperature is 25°C.
The lens shift cannot be
adjusted.
c
The lens shift cannot be adjusted over the range of movement.
Adjust the lens shift within the range of movement. (
1
pages 14, 21)