35
(EN)
Unsuitable Installation
Poorly ventilated
• Allow adequate air circulation to prevent internal heat
build-up. Do not place the unit on surfaces (rugs,
blankets, etc.) or near materials (curtains, draperies) that
may block the ventilation holes. When the internal heat
builds up due to the block-up, the temperature sensor will
function with the message “High Temperature! Power off
in 1 min.” The power will be turned off automatically
after one minute.
• Leave space of more than 30 cm (11
7
/
8
inches) around
the front ventilation holes.
• Be careful that the bottom ventilation holes may inhale
tininess such as a piece of paper.
• If you put something in front of the front ventilation
holes, the exhaust may be inhaled into the projector
through the ventilation holes at the bottom, causing the
internal temperature to rise, which activates the
protection circuit. Install the projector so that the exhaust
is not blocked.
Highly heated and humid
• Avoid installing the unit in a location where the
temperature or humidity is very high, or temperature is
very low.
• To avoid moisture condensation, do not install the unit in
a location where the temperature may rise rapidly.
Very dusty
Avoid installing the unit in a location where there is a lot of
dust; otherwise, the air filter will be obstructed. The dust
blocking the air through the filter may cause raising the
internal heat of the projector. Clean it up periodically.
Do not install the projector in the following situations. These installations
may cause mulfunction or damage to the projector.
S
T
U
]
^
_
]
Содержание VPL-X1000E
Страница 1: ...3 865 632 12 1 VPL X1000U VPL X1000E VPL X1000M Operating Instructions LCD Data Projector EN ...
Страница 4: ...4 EN ...
Страница 45: ...45 EN Top with the front cover Unit mm inches 353 1329 32 334 13 5 32 ...
Страница 46: ...47 EN ...
