32
Message Lists
Warning messages
Caution messages
Symptom
Cause and Remedy
High temp.! Light off in 1 min.
Turn off the power.
Check to ensure that nothing is blocking the ventilation holes and the air filter is not clogged.
(page 3, 35)
Frequency is out of range!
Input a signal that is within the acceptable frequency range of the unit. (page 38)
Projector temperature is high. High
Altitude Mode should be “On” if
Projector is being used at high
altitude.
Check to ensure that nothing is blocking the ventilation holes and the air filter is not clogged.
(page 3, 35)
When temperature inside the unit remains high, “High Altitude Mode” is switched to “On” in 1
minute, then the fan speed increases.
Power Saving Mode is set. Projector
will automatically enter Standby
Mode in 1 minute.
“Power Saving” is set to “Standby.” (page 23)
If no signal is input, the power turns off after 1 minute, and the projector goes into standby mode.
Symptom
Cause and Remedy
No signal is input in the selected input. Check connections. (page 9)
Not applicable!
Press the appropriate button.
Settings Lock enabled.
“Settings Lock” is set to “Level A” or “Level B.” (page 25)
x
Содержание VPL-VZ1000ES
Страница 47: ...Sony Corporation ...