GB
10
Replacing the Lamp
Replacing the Lamp
The lamp used as a light source is a
consumable product. When the lamp has
burnt out or dims, or “Please replace the
LAMP.” appears on the screen, replace the
lamp with a new one. Use LMP-F300
Projector Lamp as the replacement lamp.
The lamp life varies depending on
conditions of use.
The lamp becomes a high temperature after
turning off the projector with the
I
/
1
key.
If you
touch the lamp, you may scald your finger.
When you replace the lamp, wait for at least an
hour for the lamp to cool.
• If the lamp breaks, consult with qualified Sony
personnel.
• Pull out the lamp by holding the handle. If you
touch the lamp, you may be burned or injured.
• When removing the lamp, make sure it remains
horizontal, then pull straight up. Do not tilt the
lamp. If you pull out the lamp while tilted and if
the lamp is broken, the pieces may scatter,
causing injury.
• To erase a message, press any key on the control
panel of the projector or on the remote
commander.
1
Turn off the projector, and disconnect
the AC power cord from the AC outlet.
When replacing the lamp after using the
projector, wait for at least an hour for the
lamp to cool.
2
Place a protective sheet (cloth) beneath
the projector. Turn the projector over so
you can see its underside.
Be sure that the projector is stable after
turning it over.
3
Loosen a screw with the Phillips
screwdriver, then slide the lamp cover
and remove it.
Be sure not to remove other screws, for
safety reasons.
4
Loosen the two screws on the lamp unit
with the Phillips screwdriver.
5
While holding the handle and keeping
the lamp unit horizontal, pull straight up.
Caution
Notes
Note
Note
Note
