Sony VID-P110, Руководство по обслуживанию

Страница: 20 / 82

2-4 (E) VID-P110
2-2-2. Removal of Drum Block and Light
Ass’y L/R
Drum Block
1. Remove the cover ass’y. (Refer to section 2-1-1.)
2. Remove the table ass’y. (Refer to section 2-1-2.)
3. Disconnect one connector (CN1) on VSW-60 board,
one connector (CN7) on SY-248 board and one
connector (CN2) on PS-517 board.
4. Remove three screws “a” (PS3 x 6) and release the
camera arm stopper.
5. Remove four screws “b” (K4
x
12) not to rebound the
low load spring while pressing with your hand.
6. Remove six screws “c” (PWH4 x 10) and then remove
drum ass’y.
Light Ass’y L/R
1. Remove the cover ass’y. (Refer to section 2-1-1.)
2. Remove the table ass’y. (Refer to section 2-1-2.)
3. Disconnect two connectors (CN6, CN7) on PS-517
board.
4. Remove one screw “d” (B3 x 6) and ground terminal.
5. Remove two each screws “e” (P4 x 8) fastening pipe
support bracket L/R, one each screw “f” (B3
x
10) and
then remove light ass’y L/R.
screw "c"
(PWH4
x 10)
screw "c"
(PWH4
x 10)
screw "b"
(K4
x 12)
screw "e"
(P4
x 8)
screw "d"
(PS3
x 6)
screw "a"
(PS3
x 6)
screw "a" (PS3 x 6)
screw "f"
(B3
x 10)
screw "f"
(PS3
x 6)
screw "d"
(PS3
x 6)
screw "e"
(P4
x 8)
CN7
CN7
CN1
CN2
CN6
VSW-60 board
SY-248 board
PS-517 board
Drum block
Low load spring
Ground terminal
Ground terminal
washer
Light (R) ass'y
Light (L) ass'y
Left pipe
support bracket
Right pipe
support bracket