Sony UP-D898MD, Инструкция по эксплуатации

Страница: 28 / 31

Ot
h
e
rs
Troubleshooting
28
Troubleshooting
Before you call for service, please check the problems
and solutions described below. If you cannot solve the
problem, contact the nearest authorized dealer.
Symptom Causes/remedies
First few prints
spotted with small
dots. New paper roll just installed?
t If a new roll of paper has just been
loaded, paper dust may cause white
spots in printed images. Press the
FEED button and hold it down to
feed about 15 - 20 cm (6 - 8 in) and
then release. (page 13)
Print job does not start
even after transmitting
picture from the
computer. • Paper does not feed.
t
Power switched on?
t
Unit connected correctly?
t
Paper roll loosen?
• Alarm sounds.
t
Has the thermal head
overheated? The thermal head
may overheat when the unit
prints dark image continuously.
Wait until the head cools down.
t
Paper loaded correctly?
(page 13)
• Paper feeds but printing does not
start.
t
Paper loaded with the wrong
side up? (page 12)
Paper Jams • Jammed paper visible?
t Press the OPEN button to open
the door panel, remove the
printout or the paper roll, and
then gently pull the jammed
paper out of the unit.
• Condensation collected in unit?
t If the unit has just been brought
into a warm room from a cold
location, condensation may have
formed inside the unit. Switch
the unit off and let it set for 1 - 2
hours (until it warms to room
temperature), then try printing
again.
Printouts dirty. • Thermal head dirty?
t
Use the head cleaning sheet
provided with the unit to clean
the thermal head. (page 24)
• Platen roller dirty?
t
Clean the platen roller using a
soft cloth moistened with ethyl
alcohol. (page 25)
The unit stops printing
while printing almost
black images
continuously and the
message “COOLING”
is displayed on the
LCD. When printing almost black images
continuously, the thermal head
protection circuit may shut down the
unit to prevent the thermal head from
overheating.
t Wait for the message to disappear.
Paper is not fed
smoothly. Platen roller dirty?
t
Clean the platen roller. (page 25)
Printing is interrupted.
When printing, the
unit discharges several
centimeters of the
white paper and stops.
The print operation
cannot be performed.
The FEED operation
cannot be performed.
When the paper is set
correctly, “EMPTY” is
displayed. Does the sunlight or incandescent light
that includes strong infrared light
irradiate the paper exit?
t The unit has an infrared light sensor
that detects the printing paper.
Therefore, when the light directly
irradiates the paper exit, paper
detection may not operate correctly.
Do not expose the paper exit to
light directly.
Symptom Causes/remedies