–
12
–
KV
-PG21P40/PG21M70/PG21P70
RM-952
2-7. PICTURE TUBE REMOVAL
Note:
•
Please make sure the TV set is not in standing position before removing necessary
CRT support located on bottom right and left.
!™
!£
8
Demagnetic coil
4
Four screws
(washer head)
(BVTP 3
×
12)
!º
Two screws
(Tapping 5+
Crown Washer)
3
Speaker
(5
×
9cm)
6
Tension
spring
7
Chassis assy
5
Deflection
yoke
2
CV board
1
Anode cap
Coating earth assy
!∞
Picture tube
!¢
Cushion
9
Two screws
(Tapping 5 +
Crown Washer)
!¡
Holder DGC
Cushion (50x550) DGC
Cushion (35x250) DGC
A Board
CRT Support Block
Slim Beznet
CRT Support Block
Screw Location
•
REMOVAL OF ANODE-CAP
NOTE : After removing the anode, short circuit the anode of the picture tube and
the anode cap to the metal chassis, CRT shield or carbon paint on the
CRT.
•
REMOVING PROCEDURES
1
Turn up one side of the rubber cap in the direction indicated by the arrow
a
.
2
Using a thumb pull up the rubber cap firmly in the direction indicated by the arrow
b
.
3
When one side of the rubber cap is separated from the anode button, the anode-cap
can be removed by turning up the rubber cap and pulling it up in the direction of the
arrow
c
.
•
HOW TO HANDLE AN ANODE-CAP
1
Do not damage the surface of anode-caps with sharp shaped objects.
2
Do not press the rubber too hard so as not to damage the inside of anode-cap.
A metal fitting called the shatter-hook terminal is built into the rubber.
3
Do not turn the foot of rubber over too hard.
The shatter-hook terminal will stick out or damage the rubber.
a
a
b
b
Anode button
c
Содержание TRINITRON KV-PG21M70
Страница 25: ... 24 KV PG21P40 PG21M70 PG21P70 RM 952 MEMO ...