– 36 –
KV-EX29K94/EX34K94
RM-965
6-5. G2 (SCREEN) AND WHITE BALANCE
ADJUSTMENTS
1. G2 (SCREEN) ADJUSTMENT
1) Set the PICTURE and BRIGHTNESS to normal.
2) Put to VIDEO input mode without signals.
3) Connect R, G and B of the C board cathode to the
oscilloscope.
4) Adjust BRIGHTNESS to obtain the cathode voltage to the
value below.
5) Whilst watching the picture, adjust the screen VR
[RV9002] located on the C board to the point just before
the retrace lines disappear (to the point before cut-off)
2. WHITE BALANCE ADJUSTMENT
1) Set to Service Mode (Refer Section 7-1: ADJUSTMENTS
WITH COMMANDER).
2) Input white raster signal.
3) Set the following condition.
PICTURE minimum, BRIGHTNESS 50%
4) Select GCT (WHB 7) and BCT (WHB 8) with
[1]
and
[4]
, and adjust the level with
[3]
and
[6]
for the best
white balance.
5) Set the PICTURE to maximum.
6) Select GDR (WHB 4) and BDR (WHB 5) with
[1]
and
[4]
, and adjust the level with
[3]
and
[6]
for the best
white balance.
7) Write into the memory by pressing
[MUTING]
then
[0]
.
0 V
cathode setting voltage:
170 V ± 2 (VDC)
