17
2-8. Side Control Module Removal
2-7. B2 Board Removal
Follow the steps indicated in removal of the J board. With the
assembly removed access to the B2 board shield is possible. To
remove the shield locate and remove the two screws positioned on
either side and at opposite ends of the shield. Release the B2 board clip
and remove in a vertical direction. Please ensure that the screws are
refitted after service.
Rrelease the clip circled and pull the bracket towards the rear
of the set. The bracket can then be removed to allow access to
the boards.
Clip
Remove the two screws fixing the user control module to the
side of the set. The control module can then be removed by
sliding it towards the rear of the set allowing access to the H7
Board.
Screws
Screw
Note :
Removal of the B2, E, and M1 printed circuit boards follows the
same procedure of releasing the securing clips as indicated
in the fig for D1 board removal.
Take care not to apply to great a pressure to the clips as this may
cause damage.
2-9. F4 Bracket Removal
To remove the F4 and H8 Boards release the clips circled and
ease the boards gently away from the support bracket.
Clips
Clips
2-10. F4 and H8 Board Removal
Содержание Trinitron KV-29FX65B
Страница 30: ...30 Memo ...
Страница 36: ...E R G B OUT CHROMA 50 49 ...
Страница 37: ...51 E PRINTEDWIRING BOARD A side E PRINTEDWIRING BOARD B side ...
Страница 38: ...52 M1 PRINTED WIRING BOARD A side M1 PRINTED WIRING BOARD B side ...