Sony SU-PW2, Инструкция по эксплуатации

Страница: 15 / 84

SU-PW2 4-099-792-42(1)
GB
15
(GB)
Install the Display Unit on the Plate Unit.
1
Insert the screws (+B6
×
L20, supplied) for securing
the Mounting Hook Unit into the screw holes on the
outer left and right sides of the Mounting Hook Unit
support shafts, and then tighten them temporarily.
2
Hitch the upper hooks of the two Mounting Hook
Units on to the support shafts of the arms.
3
Place the lower hooks of the two Mounting Hook
Units so that they touch the front side of the
Mounting Hook Unit support shafts.
4
Slightly push the Display Unit toward the Plate Unit
and upward, to hitch the lower hooks of the two
Mounting Hook Units on to the Mounting Hook Unit
support shafts.
5
Confirm the eight hooks are firmly hooked on the
four shafts on the Plate Unit.
6
Firmly tighten the securing screws screwed in
temporarily in Procedure
1
.
Note
If the temporarily attached screws for securing the Mounting Hook
Unit protrude inside the Mounting Hook Unit support shafts, the
lower hooks of the Mounting Hook Units cannot be fitted in.
3
1
2
3
4
6
Tighten the screws to halfway so that they do not
protrude from the opposite side.
Mounting Hook Unit
Confirm the completion of the installation
Check the following points.
• Eight hooks of the Mounting Hook Units are firmly hooked on the four shafts on the Plate Unit.
• The lead and the cable are not twisted or pinched.
• The two securing screws on the Mounting Hook Unit support shafts are securely tightened.
WARNING
Incomplete installation may cause the product falling and result in injury or product damage. Also, improper
placement of the mains lead, etc., may cause fire or electric shock through a short circuit.
Be sure to confirm the completion of the installation for safety.