28
GB
Troubleshooting
If you experience any of the following difficulties while
using the receiver, use this troubleshooting guide to help
you remedy the problem. Also, see page 9 to verify that
the connections are correct. Should any problem persist,
consult your nearest Sony dealer.
There’s no sound or only a very low-level sound
is heard.
,
Check that the speakers and components are
connected securely.
,
Make sure that you’ve selected the correct
component on the receiver.
,
Press MUTING on the remote if the MUTING
indicator is lit.
,
Use the i.LINK connecting cable for 200 Mbps
transmission rate.
,
The protective device on the receiver has been
activated because of a short circuit. Turn off the
receiver, eliminate the short-circuit problem and
turn kn the power again.
The left and right sounds are unbalanced or
reversed.
,
Check that the speakers and components are
connected correctly and securely.
,
Adjust speaker balance using Sound Menu (page
16).
Severe hum or noise is heard.
,
Check that the speakers and components are
connected securely.
,
Check that the connecting cables are away from a
transformer or motor, and at least 3 meters away
from a TV set or fluorescent light.
,
Move your TV away from the audio components.
,
The connectors are dirty. Wipe them with a cloth
slightly moistened with alcohol.
Recording can’t be done.
,
Check that the components are connected correctly.
Radio stations can’t be tuned in.
,
Check that the antennas are connected securely.
Adjust the antennas and connect an outdoor
antenna if necessary.
,
The signal strength of the stations is too weak
(when tuning in with automatic tuning). Use
manual tuning.
,
No stations have been preset or the preset stations
have been cleared. Preset the stations (see page
19).
Additional
Information
