![Sony STR-K880 Скачать руководство пользователя страница 2](http://html.mh-extra.com/html/sony/str-k880/str-k880_service-manual_417223002.webp)
2
STR-K880/K900
Notes on chip component replacement
•
Never reuse a disconnected chip component.
•
Notice that the minus side of a tantalum capacitor may be
damaged by heat.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the lead-
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
•
Unleaded solder melts at a temperature about 40
°
C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350
°
C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
•
Strong viscosity
Unleaded solder is more viscou-s (sticky, less prone to flow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
•
Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
MODEL IDENTIFICATION
– Rear Panel –
Model
Part No.
US model
2-663-098-0
[]
Canadian model
2-663-098-1
[]
AEP, UK models
2-663-098-2
[]
E51 model
2-663-098-3
[]
SP, SP6 models
2-663-098-4
[]
AUS model
2-663-098-5
[]
Parts No.
• Abbreviation
AUS
: Australian model
CND
: Canadian model
E51
: Chilean and Peruvian models
SP
: Singapore model
SP6
: Singapore and Malaysia models
Reproduction frequency range
28 - 20,000 Hz
Tone
FM tuner section
Tuning range
87.5 - 108.0 MHz
Antenna
FM wire antenna
Antenna terminals
75 ohms, unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
Models of area code US, CND
With 10-kHz tuning scale:
530 – 1,710 kHz
3)
With 9-kHz tuning scale:
531 – 1,710 kHz
3)
Antenna
Loop antenna
Intermediate frequency
450 kHz
3)
You can change the AM tuning scale to 9 kHz or
10 kHz. After tuning in any AM station, turn off
the receiver. While holding down TUNING
MODE, press
?/1
. All preset stations will be
erased when you change the tuning scale. To reset
the scale to 10 kHz (or 9 kHz), repeat the
procedure.
Video section
Inputs/Outputs
Video:
1 Vp-p, 75 ohms
COMPONENT VIDEO:
Y: 1 Vp-p, 75 ohms
P
B
/C
B
/B-Y: 0.7 Vp-p,
75 ohms
P
R
/C
R
/R-Y: 0.7 Vp-p,
75 ohms
80 MHz HD Pass Through
Gain levels
±
6 dB, 1 dB step
General
Power requirements
Power consumption
Power consumption (during standby mode)
0.2 W
Dimensions (w/h/d) (Approx.)
430 157.5 316
mm
(167/8 62 /8
124/ 8
inches) including
projecting parts and
controls
Mass (Approx.)
8.0 kg (17 lb 11 oz)
Area code
Power requirements
US, CND
120 V AC, 60 Hz
Area code
Power consumption
US
170 W
CND
230 VA
Models of area code E51
With 10-kHz tuning scale:
530 – 1,610 kHz
3)
With 9-kHz tuning scale:
531 – 1,602 kHz
3)
Models of area code AEP, UK, AUS, SP, SP6
With 9-kHz tuning scale:
531 – 1,602 kHz
Antenna
Loop antenna
Intermediate frequency
450 kHz
AEP, UK
230 V AC, 50/60 Hz
AUS
240 V AC, 50 Hz
SP, SP6
230 – 240 V AC,
50/60 Hz
E51
120/220/240 V AC,
50/60 Hz
AEP, UK, AUS, SP,
SP6, E51
200 W
×
×
×
×
Design and specifications are subject to
change without notice.
Ver. 1.1
Содержание STR-K880
Страница 67: ...67 STR K880 K900 MEMO ...