STR-DH730/DH830
4
SECTION 1
SERVICING NOTES
Part No.
MODEL IDENTIFICATION
–BACK PANEL–
Model
Part No.
US
4-408-555-0
[]
CND
4-408-555-1
[]
AUS, ECE
4-408-555-2
[]
•
Abbreviation
AUS :
Australian
model
CND : Canadian model
ECE : Continental European, East European and
Russian models
Notes on chip component replacement
• Never reuse a disconnected chip component.
• Notice that the minus side of a tantalum capacitor may be
damaged by heat.
UNLEADED SOLDER
Boards requiring use of unleaded solder are printed with the
lead-free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size)
: LEAD FREE MARK
Unleaded solder has the following characteristics.
• Unleaded solder melts at a temperature about 40 °C higher
than ordinary solder.
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
about 350 °C.
Caution: The printed pattern (copper foil) may peel away if
the heated tip is applied for too long, so be careful!
• Strong
viscosity
Unleaded solder is more viscous (sticky, less prone to
fl
ow)
than ordinary solder so use caution not to let solder bridges
occur such as on IC pins, etc.
• Usable with ordinary solder
It is best to use only unleaded solder but unleaded solder may
also be added to ordinary solder.
Special Component Notice
The components identi
fi
ed by mark
9
contain con
fi
dential
information.
Strictly follow the instructions whenever the components are
repaired and/or replaced.
Notice pour composants spéciaux
Les composants identi
fi
és par la marque
9
contiennent des
informations con
fi
dentielles.
Suivre scrupuleusement les instructions chaque fois qu’un com-
posant est remplacé et / ou réparé.
NOTE OF REPLACING THE IC4100 ON THE USB BOARD
IC4100 on the USB board cannot exchange with single. When this
part on the USB board is damaged, exchange the entire mounted
board.
NOTE OF REPLACING THE IC2106 ON THE DIGITAL
BOARD
IC2106 on the DIGITAL board cannot exchange with single.
When this part on the DIGITAL board is damaged, exchange the
entire mounted board.
NOTE OF REPLACING THE IC3500 AND IC3501 ON THE
D-VIDEO BOARD
IC3500 and IC3501 on the D-VIDEO board cannot exchange
with single. When these parts on the D-VIDEO board are damaged,
exchange the entire mounted board.
MICOM (IC2105) ON DIGITAL BOARD SERVICE POSITION
• In checking the MICOM (IC2105) on the DIGITAL board,
prepare a set of extension jigs (A-1825-238-A) which consists
of two extension cables.
not used
Connect jig to the DIGITAL board (CN2513 (20P)),
(CN2603 (8P)) and D-VIDEO board (CN3003 (20P)),
(CN3004 (8P)).
D-VIDEO board
DIGITAL board
Extension jigs
(A-1825-238-A)
Содержание STR-DH830
Страница 93: ...MEMO 93 STR DH730 DH830 ...