21
Getting Started
Dolby Surround Setup
z
If you feel the surround effect is inadequate
Do the procedure below to adjust the delay time for the
center and rear speakers.
1
Press SET UP repeatedly to select OTHER SETUP.
2
Use the digital processing control buttons (
V
/
v
) to
select CENTER DELAY or REAR DELAY and use the
buttons (
B
/
b
) to select the delay time.
Adjusting the speaker volume
Z
Use the remote while seated in your listening position
to adjust the volume of each speaker.
Note
This receiver incorporates a new test tone with a frequency
centered at 800 Hz for easier speaker volume adjustment.
DPC MODE
DIGITAL
PROCESSING
CONTROL
TEST TONE
SOUND FIELD
ON/OFF
GENRE
MODE
SLOPE
BAND
EQ/
TONE
DIGTAL
PROCESSING
CONTROL
PROGRAMMABLE
— LEVEL —
DIRECT
REAR
BASS
BOOST
MUTING
CENTER
MASTER
VOL
MODE
GENRE
— SOUND FIELD —
ON/OFF
TEST
TONE
+
+
–
–
POSITION
–
SUB CH
+
— RMS —
SWAP
ANT
TV/VTR
=
)
0
+
D. SKIP
CLEAR
DIRECTION
P IN P
JUMP
p
(
DPC
MODE
9
P
r
1
Press SOUND FIELD ON/OFF to turn on the
sound field.
2
Press GENRE repeatedly to select “DOLBY.”
3
Press MODE to select “NORMAL SURROUND”
or “ENHANCED SURROUND.”
4
Press DPC MODE repeatedly until the SUR
indicator lights up.
5
Press TEST TONE.
You will hear the test tone from each speaker in
sequence.
Select
During adjustment of the respective speaker level/
balance, the test tone is output from the speaker(s)
only.
After adjusting the subwoofer level, the test tone
turns off automatically.
To turn off the test tone
Press TEST TONE.
Notes
• Be sure to select “NORMAL SURROUND” or
“ENHANCED SURROUND” before outputting the test
tone.
• The test tone is not output when:
— The DIRECT PASS button is on.
— ”MUTING” appears in the display.
To adjust
subwoofer
level
SUB WOOFER
And set between
rear speaker
balance
REAR L R
L (left) and R (right)
rear speaker
level
REAR
–20.0dB and +10.0dB
(in 0.5 dB steps)
center speaker
level
CENTER
–20.0dB and +10.0dB
(in 0.5 dB steps)
–20.0dB and +10.0dB
(in 0.5 dB steps)
6
From your listening position, use the digital
processing control buttons (
/
) to select the
parameter to be set and use the buttons (
/
)
to select the setting so that the test tone can be
heard at the same level from all speakers.
