Ampl
ifier O
p
e
ration
masterpage:Right
lename[E:\SEM_Janet\Revision_DA3100ES\J9050000_2514877121STRDA3100ESU\251487
121\GB04BSC_STR-DA3100ES-U.fm]
model name1[STR-DA3100ES]
[2-514-877-
12
(1)]
25
US
You can listen to FM and AM broadcasts
through the built-in tuner. Before operation,
make sure you have connected the FM and AM
antennas to the receiver (see page 14).
Tip
The tuning scale is:
FM: 100 kHz
AM: 10 kHz*
* The AM tuning scale can be changed (see page 76).
Automatic tuning
1
Rotate INPUT SELECTOR to select
tuner (“FM” or “AM”).
2
Press FM/AM to select “FM” or “AM”.
3
Press or TUNING –.
Press to scan from low to high;
press TUNING – to scan from high to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and
“STEREO” flashes in the display, select
monaural audio so that the sound will be less
distorted.
1
Rotate MAIN MENU to select “TUNER”.
2
Rotate MENU to select “FM MODE”.
3
Rotate –/+ to select “MONO”.
The FM reception switches to monaural.
Direct tuning
You can enter the frequency of the station you
want directly. Use the remote for this operation.
1
Move the easy scroll key to select
“TUNER”, then press the key
repeatedly to select “FM” or “AM”.
You can also use INPUT SELECTOR on
the receiver.
2
Press D.TUNING on the remote.
3
Press the numeric buttons to enter the
frequency.
Example 1: FM 102.50 MHz
Select 1
b
0
b
2
b
5
Example 2: AM 1,350 kHz
Select 1
b
3
b
5
b
0
(You do not have to enter the last “0” when
the tuning scale is set to 10 kHz.)
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
If you cannot tune in a station
and the entered numbers flash
Make sure you have entered the right frequency.
If not, repeat step 3. If the entered numbers still
flash, the frequency is not used in your area.
Listening to FM/AM radio
GB01COV_STR-DA3100ES-U.book Page 25 Monday, March 28, 2005 4:08 PM
