9
Tuner unit
Tuner cover
Installation of The Tuner Unit
1
Turn off the power of this unit.
2
Remove the tuner cover.
3
Check the up and down sides of the tuner unit, and
insert it into the slot.
The upper slot corresponds to MIC1 and the lower slot
to MIC2. (Set the group and channel of the tuner unit
to same as wireless microphone's one.)
NOTICE
To prevent breakdown or injury, do not put your hand
inside of the slot except when you install or remove the
tuner unit.
Insert it deeply into the compart-
ment.
Do not insert or remove the tuner
unit while the power is on. This
may be cause of noise or
malfunction of the connector.
4
Fix the tuner cover.
After installation of the tuner unit, turn on the power
of the unit and turn on the power of the wireless
microphone to check it is receiving. While receiving,
the RF/SIGNAL indicator lights up. Note that the
RF/SIGNAL indicator will not light up when the
setting channel of the microphone is different from
the setting of the tuner unit, or when the microphone
power is consumed.
Notes
Take the following precautions to prevent interference
and noise.
• If there is a TV broadcasting station nearby, to avoid
possible interference from its broadcasting, do not
use that station's channel.
• When simultaneously using two tuners, always set
the tuners to different channels within the same group
(other than group 00).
• Please make a choice of model in accordance with
your area to use picking up an unused TV channel.
• Make sure that the channel selected on the micro-
phone is the same as that selected on the tuner being
used in the same system.
