– 9 –
6. Data In Check
Setting:
Procedure:
1. Change the modulation of SSG to 200 Hz (±4 kHz deviation).
2. Set the
[DIAL MODE]
switch (S1) to the
[P]
(PULSE) position
(SPP-ID300) .
3. Press the
[PAGE]
key (S4) eleven times (SPP-ID300) or the
[SPEAKERPHONE]
key (S2) twice (SPP-ID400) to change the
test mode step to DATA IN CHECK.
4. Check that the CHARGE LED (D11) lights up or blinks.
Adjustment Location:
SSG
Carrier frequency: 49.83 MHz
Modulation: 200 Hz,
±
4 kHz deviation
Output level: 3 dB
µ
EFM
TP (ANT)
TP (GND)
TP (TX VCO)
TP (RX VCO)
TP (ANT)
TP (GND)
TP (DISC)
J1
S1
T (TONE)
P (PULSE)
L10 TX VCO Adjustment
L7 RX VCO Adjustment
L3 DISCRI Coil Adjustment
L6 Sensitivity Adjustment
RT2 TEL Out Level Adjustment
– BASE (MAIN) BOARD (Component Side) –
– BASE (MAIN) BOARD (Conductor Side) –
˜
