A
d
mini
s
tra
ting
t
he
Came
ra
Configuring the Network — Network setting Menu
25
Default gateway
Type the default gateway.
Obtain DNS server address automatically
Select this to obtain the address of DNS server
automatically. It can be set only when
Obtain an IP
address automatically (DHCP)
is selected.
Note
When you select “Obtain DNS server address
automatically”, make sure that DHCP server is active on
the network.
Use the following DNS server address
Select this when you set the fixed address as the IP
address of DNS server.
Primary DNS server
Type the IP address of the primary DNS server.
Secondary DNS server
Type the IP address of the secondary DNS server, if
necessary.
HTTP port number
Normally select
80
. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port number to a number
other than 80 on the Network setting page or in the Setup
Program, access the camera by typing the IP address of
the camera on the web browser, as follows:
Example: when HTTP port number is set to 8000
OK/Cancel
See “Buttons common to every setting menu” on page
17.
Wireless network Tab (SNC-M1W
only)
Use this to set connection for the wireless network.
SSID
Type the ID to identify the wireless network you want to
access using up to 32 ASCII characters (alphanumeric).
For your security, be sure to change the factory setting.
Type
Select the network connection type
Adhoc mode
or
Infrastructure mode
. Select
Adhoc mode
when
connecting to the computer directly, or select
Infrastructure mode
when connecting to the computer
via an access point or a radio router. When you select
Ad
hoc mode
, specify the wireless channel.
Channel
Set the channel when making adhoc connection is set up.
Tip
Set the channel of the computer and a camera as the sa
me value.
Note
For better wireless communication, check for the
channel used by the operating network and select the
channel that is used less.
WEP
Select
On
when you use the WEP (Wired Equivalent
Privacy) keys, or
Off
when you do not use it.
The WEP key data settings are valid only when the WEP
menu is set to
On
.
WEP key data
Specify up to 4 WEP keys. The length of a WEP key is
40 or 104 bit. A 104-bit WEP key has a higher security
level than a 40-bit key. You can type the WEP key either
in hexadecimal numbers (0 to 9 and A to F) or ASCII
characters (alphanumeric).
