SA-WSIS10/SS-IS10
13
13
SA-WSIS10/SS-IS10
•
Note for Printed Wiring Boards and Schematic Diagrams
•
Circuit Boards Location
Note on Printed Wiring Board:
•
X
: parts extracted from the component side.
•
Y
: parts extracted from the conductor side.
•
f
: internal component.
•
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen from
(Conductor Side)
the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side) the parts face are indicated.
CONNECTOR board
AMP board
DSP board
SPEAKER board
POWER board
– SA-WSIS10 –
Note on Schematic Diagram:
•
All capacitors are in
µ
F unless otherwise noted. (p: pF)
50 WV or less are not indicated except for electrolytics
and tantalums.
•
All resistors are in
Ω
and
1
/
4
W or less unless otherwise
specified.
•
f
: internal component.
•
2
: nonflammable resistor.
•
5
: fusible resistor.
•
C
: panel designation.
•
A
: B+ Line.
•
Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
no mark : TUNER (FM/AM)
∗
: Impossible to measure
•
Voltages are taken with a VOM (Input impedance 10 M
Ω
).
Voltage variations may be noted due to normal produc-
tion tolerances.
•
Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal produc-
tion tolerances.
•
Circled numbers refer to waveforms.
•
Signal path.
F
: AUDIO
•
Abbreviation
AR
: Argentina model
AUS
: Australian model
CH
: Chinese model
CND : Canadian model
E32
: Latin America models except Argentina
EA
: Saudi Arabia model
RU
: Russian model
SP
: Singapore model
TH
: Thai model
TW
: Taiwan model
Note:
The components identi-
fied by mark
0
or dotted
line with mark
0
are criti-
cal for safety.
Replace only with part
number specified.
Note:
Les composants identifiés par
une marque
0
sont critiques
pour la sécurité.
Ne les remplacer que par une
pièce por tant le numéro
spécifié.