Sony RMT-V231B, Руководство по обслуживанию

Страница: 58 / 76

6-3
2-3. SERVO SYSTEM CHECK
Unless otherwise specified, set the switches to the following
positions.
• INPUT SELECT switch ............................................ LINE 1
• TAPE SPEED switch ......................................................... SP
2-3-1. RF Switching Position/
AF Switching Position Adjustments
(MA-327 Board)
[Adjustment Purpose]
To adjust the link of the A-ch and B-ch of the tape playback outputs.
To make the unit compatible with other tapes and units. If this
specification is not satisfied, the link will appear on the screen and
the screen will be disrupted, etc.
Mode Playback
Signal Alignment tape: SP color bar portion
Measurement point CH1: Video LINE OUT
(RF switching position)
CN341 pin
1
(HF ADJ)
(AF switching position)
CH2: CN261 pin
3
(RF SWP)
Measuring instrument Oscilloscope
Specified value 6.5 ± 0.5H (410 ± 32
µ
sec)
[Adjustment Method]
1)
Short-circuit between JS161 and ground for about 1 second to
activate the RF switching position adjustment mode.
2) Check that “AP” is indicated on FL display.
3) Using the c and – buttons, adjust to 410 ± 32
µ
sec (6.5
± 0.5H).
4) Press the PAUSE button. (Adjustment is over for mono models.)
5) The set goes to the AF switching position adjustment mode.
Fig. 6-2-3.
6) Check that “AH” is indicated on FL display.
7) Using the c and – buttons, minimize a chipped portion.
At this time, confirm that a noisy sound is not heard.
8) Press the PAUSE button.
9) Check that “AH” indication is disappeared. When it is not
disappeared, repeat from the item 1).
10) Press the STOP button.
11) Press the EJECT button.
Fig. 6-2-4.
CN261 pin
3
6.5
±
0.5H
CH1
CH2
CH1
CH2
Enlarrgement
Vertical sync. signal
Approx.
5Vp-p
Approx.
1Vp-p
V
CH2
RF SWP
CN261 pin
3
CH1
REC AFM
CN341
pin
1
OK
NG
Should be minimized
RF signal dropout