Ad
v
a
nced Re
mote
Ope
rations
masterpage:Right
filename[\\B-02w2000e\SONY RM-
PP412\4247244111\424724411RMPP412CEL\GB04ADV_RM-PP412-CEL.fm]
9
GB
model name1[RM-PP412]
[4-247-244-11(1)]
This chapter describes how to set the remote to
control non-Sony components.
You can program the remote to control non-
Sony components. Once the control signals have
been memorized, you can use those components
as part of your system.
Furthermore, you can also program the remote
for Sony components that the remote is unable to
control. Note that the remote can only control
components that accept infrared wireless control
signals.
Note
You cannot program the SOURCE button.
1
Press AV
?/1
while holding down USE
MODE
.
The USE MODE button lights.
2
Press one of the input buttons to select
the input you want to control.
For example, if you are going to control a
CD player, press CD/SACD.
You can also select the
TV
?/1
button.
3
Press the numeric buttons to enter the
numeric code (or one of the codes if
more than one code exists)
corresponding to the component and
the maker of the component you want
to control.
See the tables starting from page 10 for
information on the numeric code(s)
corresponding to the component and the
maker of the component. (The first digit and
the last two digits of the numeric code
correspond to the category and the maker’s
code respectively.)
4
Press ENTER.
Once the numeric code has been verified,
the USE MODE button slowly flashes
twice and the remote automatically exits the
programming mode.
5
Repeat steps 1 to 4 to control other
components.
To cancel programming
Press USE MODE during any step. The remote
automatically exits the programming mode.
To use the programmed input
Press the programmed input buttons.
If programming is unsuccessful,
check the following:
• If the
USE MODE
button does not light up in step
1, the batteries are weak. Replace both batteries.
• If the
USE MODE
button flashes 4 times in quick
succession while entering the numeric code, an error
has occurred. Start again from step 1.
• In step 1, the remote automatically exits the
programming mode if 60 seconds has passed after
pressing USE MODE. Start again from step 1.
Notes
•
The USE MODE
button turns off while a valid
button is pressed.
• In step 2, if you press the input buttons several times,
only the last selected input is valid.
• In step 2, if you press TV
?/1
, only TV VOL +/–,
TV CH +/–, TV/VIDEO and WIDE buttons are
reprogrammed.
• In step 3, if you press the input buttons, the new input
is selected and the programming procedure returns to
the beginning of step 3.
• For the numeric codes, only the first three numbers
entered are valid.
To clear the memory of the
remote
Press
?/1
, AV
?/1
and MASTER VOL – at the
same time. The USE MODE
button flashes 3
times, then goes off.
The numeric codes
corresponding to the
component and the maker of
the component
Use the numeric codes in the tables below to
control non-Sony components and also Sony
components that the remote is normally unable
to control. Since the remote signal that a
component accepts differs depending on the
Advanced Remote Operations
Programming the remote
continued
