Connecting via i.LINK (FAT only)
113
Conn
ec
ti
ng Ex
te
rn
al De
v
ic
e
s
When the camcorder is displaying thumbnails or
in playback mode, you can transfer an HDV
stream to a nonlinear editing system connected
via the i.LINK (HDV/DV) connector.
Notes
• The i.LINK (HDV/DV) connector of this camcorder is
a 4-pin connector. Check the number of pins of the
i.LINK connector on your computer and use an
appropriate i.LINK cable.
• In searching pictures of this camcorder on the
computer, it may take some time until the display is
reflected on the computer.
• If the playback clip is short or the playback starting
point is near the end of the clip, the i.LINK signal may
be interrupted between the clip and the next clip. When
you try to capture such a signal using the nonlinear
editing system, a malfunction may occur, depending
on the nonlinear editing software in use.
• If you specify a search speed other than 4, 15, or 24
times normal with the nonlinear editing system, no
i.LINK signal is fed out. In such a case, the picture on
the viewfinder screen may stay frozen.
• High-speed playback picture may not be displayed on
the computer screen, depending on the nonlinear
editing software in use.
Setting on this camcorder
Set “SDI/HDMI/i.LINK I/O Select”
the VIDEO SET menu to “HDV” or “DVCAM.”
The input from a device connected via the i.LINK
(HDV/DV) connector can be recorded on an SxS
memory card in this camcorder. The timecodes
superimposed on the i.LINK input are recorded
regardless of the settings of the camcorder.
1
Set the external signal to a format that
can be recorded on the camcorder.
setting of this unit, recordable input signals are
as follows:
• FAT HD Mode
SP 1440×1080/59.94i or SP 1440×1080/
23.98P: HDV stream signal of 1440×1080/
59.94i
SP 1440×1080/50i: HDV stream signal of
1440×1080/50i
• FAT SD Mode
DVCAM59.94i, 29.97P SQ/EC: DVCAM
stream signal of 720×480/59.94i
DVCAM50i, 25P SQ/EC: DVCAM stream
signal of 720×576/50i
Other video formats and combination of input
signals cannot be recorded.
2
Set “SDI/HDMI/i.LINK I/O Select”
in the VIDEO SET menu to
“HDV.”
3
in
the VIDEO SET menu to “i.LINK.”
The input image is displayed on the
viewfinder
screen and the monitor connected via the
VIDEO OUT connector.
The audio signal is output from the built-in
speaker, headphones connected to the
headphone connector, and the speaker of the
monitor connected to the AUDIO OUT
connector.
4
Press the REC START/STOP button
(
Recording begins.
Notes
• An error is generated in the following cases. In such a
case, cancel Recording mode by pressing the REC
START/STOP button.
—The video format of input signal does not match
that specified on the camcorder.
—A copy-protected stream is being fed in.
• If the input to the camcorder becomes no signal during
recording, the tally lamps and the i.LINK
z
REC status
indication on the viewfinder screen flash, indicating
that no signal is being recorded on the SxS memory
card.
When an input signal is resumed, recording is
restarted, incrementing the clip number on the memory
card.
Nonlinear Editing
Recording External Input Signals
Содержание PMW300K1
Страница 151: ......
