Sony PMW-TD300, Руководство по эксплуатации

Страница: 76 / 185

Basic Operations 76
Ch
apt
er 4
S
hoo
tin
g
This section explains the basic shooting and
recording procedures.
Before starting to shoot, inspect the camera
system to verify that it is operating properly.
1
Attach a fully charged battery pack (see
page 38) .
2
Load one or two SxS memory cards (see
page 72) .
When recording in 3D, insert memory cards
in both the left and right slots. If memory
cards are inserted in both slots A and B, the
camcorder automatically switches to the
second card when the first card becomes full.
3
Set the camcorder’s POWER switch
(see page 18) to ON.
4
Make the following settings.
3D/2D: 3D or 2D (see page 53)
Marker display: On (see page 115)
Iris: Auto (see page 59)
Zoom: Auto (see page 60)
Camera output: Select the picture currently
being shot (camera picture), and turn the
DCC function on
(see page 24)
Timecode advance mode: F-RUN (Free
Run) or R-RUN (Rec Run) (see page 67)
Audio input channel selection: Auto (see
page 31)
5
Push the AUTO W/B BAL switch to the
BLACK side to adjust the black balance
(see page 54) .
6
Select a filter according to the lighting
conditions, and adjust the white balance
(see page 55) .
7
Point the camcorder at the subject, and
adjust the focus
(see page 61) and zoom.
8
When recording in 3D, adjust the
convergence
(see page 62) .
9
If you are using the electronic shutter,
select an appropriate shutter mode and
speed
(see page 57) .
10
Do one of the following to start
recording.
- Press the REC START button (see
page 22) .
- Press the VTR button (see page 20) .
- Turn on the assignable switch to which the
Rec function has been assigned (see
page 146) .
During recording, the TALLY indicators, the
tally indicator on the front panel of the
viewfinder, and the REC indication on the
viewfinder screen light. Adjust the zoom and
focus as required.
Notes
• Never remove the battery pack while the
camcorder is recording (while the ACCESS lamp
on the right-side panel is lit in blue and the
ACCESS lamp in the card slot section is lit in
orange). Doing so risks the loss of several
seconds of data before the recording was
interrupted, because internal processing will not
end normally.
• The playback control buttons (EJECT, F REV, F
FWD, NEXT, PREV, PLAY/PAUSE, STOP) do
not function during recording.
11
To stop recording, perform one of the
operations listed in step
9
.
The TALLY indicators, the tally indicator on
the front panel of the viewfinder, and the
REC indication on the viewfinder screen go
out, and camcorder enters recording standby
(STBY) mode.
A clip is created from the video and audio
data and the metadata recorded between steps
9
and
10
.
To check the recording (recording review)
With the camcorder in recording standby
(STBY) mode, turn on the assignable switch
to which the Rec Review function or the
Freeze Mix function has been assigned
(see
page 145) .
The camcorder plays the entire last clip, or
the last few seconds of that clip (3 seconds or
10 seconds), and then returns to standby
mode.
Basic Operations